Design largely decides what a turned part costs. Of two parts doing the same job, one comes off the lathe in minutes in a single set-up, while the other needs special tools, extra set-ups and slow cutting. These eight decisions make a part faster and more consistent to produce without giving up function.
1. Keep the length-to-diameter ratio reasonable
Parts that are very long for their diameter deflect under cutting forces; chatter spoils the surface and size drifts. They need tailstock or steady-rest support and slower cutting. Shorten the part or increase the diameter where you can.
2. Allow a radius in internal corners
The insert has a nose radius, so a perfectly sharp corner cannot form at a shoulder. Allowing a small radius permits standard tooling and reduces stress concentration.
3. Add relief grooves where a mating part seats
If a bearing or bushing must sit flat against a shoulder, the corner radius gets in the way. A small relief groove solves it and gives a grinding wheel room to run out.
4. Use standard threads with a chamfer and run-out
Standard metric threads are cut and gauged with stock tooling. Put a chamfer at the start and a run-out groove at the end; full thread right up to a shoulder makes the job harder.
5. Avoid deep, narrow bores
The deeper the bore, the harder chip evacuation becomes and the more the boring bar deflects. Ask for precise diameters only over the length that needs them.
6. Take care with thin walls
Thin-walled parts go out of round under chuck pressure and change size when released. Keep the wall as thick as possible, or set the roundness tolerance realistically.
7. Tolerance only where it is needed
Fits and bearing diameters need tight tolerances; free surfaces do not. A general tolerance standard is enough for untoleranced dimensions.
8. Design close to standard bar sizes
Choosing the largest diameter close to an available bar size reduces both the material turned into chips and the machining time.
More about our service on the CNC Turning page.