Prototipten seri üretime, kalıptan bitmiş parçaya — İzmir'den. E-posta: info@oskakalip.com Telefon: 0506 462 17 78 WhatsApp Sohbeti Teklif Başlat
Fiyat teklifi alın

Ana Sayfa / Haberler

Aluminium 6061 or 7075? Choosing an Alloy for CNC Parts

Kasım 16, 2026

Türkçe sürüm

When an aluminium part is to be CNC machined, the most frequent question is which alloy to use. The two most common options are 6061 (with 6082 as its close European counterpart) and 7075. Both machine well, but they do not give the same result.

Quick comparison

Property 6061 / 6082 (T6) 7075 (T6)
Main alloying elements Magnesium and silicon Zinc
Tensile strength (approx.) ~310 MPa ~540–570 MPa
Hardness Medium Markedly higher
Weldability Good Poor; welding not advised
Corrosion resistance Good Lower; needs protection
Anodising Even, decorative result Possible; colour may be less uniform
Cost More economical, widely available More expensive

When 6061 / 6082 is the right choice

  • General-purpose parts: brackets, housings, covers, fixtures, guards.
  • Parts that will be welded.
  • Outdoor or humid service.
  • Visible surfaces needing even, coloured anodising.
  • When cost matters and loads are not at the limit.

When 7075 is the right choice

  • Highly loaded parts where weight is critical.
  • Thin sections that must resist bending and bearing loads.
  • Threads and seating faces that must last without deforming.
  • Short-run prototype molds or mold inserts.

Machining differences

Both alloys cut comfortably at high speeds. 7075 is harder, so its chips break short and the surface comes out clean; 6061 is softer and tends to build up on the tool without suitable tooling and coolant. On parts hollowed out of large plates, internal stresses can cause distortion; using stress-relieved plate and letting the part rest between roughing and finishing improves dimensional stability.

Kalıp ve hassas parça işleriniz için üretim ortağınız

Kokil, plastik enjeksiyon ve alüminyum enjeksiyon kalıpları ile CNC talaşlı imalat tek atölyede. Teknik resminizi gönderin, birlikte değerlendirelim.

Bize Ulaşın
Kasım 16, 2026

Stainless Steel Grades in CNC Machining: 303, 304, 316, 420 and 17-4 PH

Devamını oku
Kasım 16, 2026

CNC İşlemede Paslanmaz Çelik Türleri: 303, 304, 316, 420 ve 17-4 PH

Devamını oku
Tüm haberler ve yazılar