Prototipten seri üretime, kalıptan bitmiş parçaya — İzmir'den. E-posta: info@oskakalip.com Telefon: 0506 462 17 78 WhatsApp Sohbeti Teklif Başlat
Fiyat teklifi alın

Ana Sayfa / Haberler

Insert Molding and Overmolding: Differences and Design Rules

Kasım 16, 2026

Türkçe sürüm

A single plastic part cannot do everything: sometimes it needs a metal thread inside it, sometimes a soft grip on top. Two methods solve this in the mold, without an assembly step: insert molding and overmolding. The names are often confused, yet the difference changes the mold design from the start.

What is insert molding?

A pre-made component, usually a metal bushing, nut, pin or contact, is placed in the cavity and plastic is molded around it. Once the plastic cools, the insert is permanently embedded. Housings with threaded brass inserts, knobs with metal shafts and terminal blocks with contacts are typical examples.

  • Heat-staking or ultrasonic insertion afterwards is eliminated.
  • A metal thread survives far more assembly cycles than a plastic one.
  • The insert needs knurling, grooves or a shoulder so it cannot pull out or rotate.
  • It is located in the mold by a pin or pocket and must not move under injection pressure.

What is overmolding?

A rigid plastic substrate is molded first, then placed in a second cavity where a second material, usually a soft thermoplastic elastomer (TPE or TPU), is molded over it. Tool handles, toothbrushes, lids with integrated seals and impact-absorbing corners are made this way.

  • Grip, vibration damping and sealing are combined in one part.
  • Bonding depends on chemical compatibility; not every TPE adheres to every rigid plastic.
  • Where compatibility is weak, the bond is made mechanical with holes and undercuts.
  • The edge where the second material ends must be a clean steel-to-steel shut-off, otherwise flash forms.

The difference

Insert molding Overmolding
Placed in the mold A ready insert, usually metal A previously molded plastic substrate
Purpose Durable threads, conductivity, reinforcement Soft touch, sealing, two colours
Tooling One mold Usually two cavities or two molds
Critical point Locating and anchoring the insert Material compatibility and shut-off

Design points

  • Keep enough plastic around the insert; a thin wall cracks as it cools.
  • A cold metal insert creates stress around it; large inserts may need preheating.
  • Do not leave the soft layer too thin; thin edges tend to peel.
  • Ending the soft material in a groove improves both appearance and adhesion.
  • Fix the material pair and insert dimensions before mold design begins.

Kalıp ve hassas parça işleriniz için üretim ortağınız

Kokil, plastik enjeksiyon ve alüminyum enjeksiyon kalıpları ile CNC talaşlı imalat tek atölyede. Teknik resminizi gönderin, birlikte değerlendirelim.

Bize Ulaşın
Kasım 16, 2026

Stainless Steel Grades in CNC Machining: 303, 304, 316, 420 and 17-4 PH

Devamını oku
Kasım 16, 2026

CNC İşlemede Paslanmaz Çelik Türleri: 303, 304, 316, 420 ve 17-4 PH

Devamını oku
Tüm haberler ve yazılar