Prototipten seri üretime, kalıptan bitmiş parçaya — İzmir'den. E-posta: info@oskakalip.com Telefon: 0506 462 17 78 WhatsApp Sohbeti Teklif Başlat
Fiyat teklifi alın

Ana Sayfa / Haberler

8 Design Tips for Turned Parts

Kasım 16, 2026

Türkçe sürüm

Design largely decides what a turned part costs. Of two parts doing the same job, one comes off the lathe in minutes in a single set-up, while the other needs special tools, extra set-ups and slow cutting. These eight decisions make a part faster and more consistent to produce without giving up function.

1. Keep the length-to-diameter ratio reasonable

Parts that are very long for their diameter deflect under cutting forces; chatter spoils the surface and size drifts. They need tailstock or steady-rest support and slower cutting. Shorten the part or increase the diameter where you can.

2. Allow a radius in internal corners

The insert has a nose radius, so a perfectly sharp corner cannot form at a shoulder. Allowing a small radius permits standard tooling and reduces stress concentration.

3. Add relief grooves where a mating part seats

If a bearing or bushing must sit flat against a shoulder, the corner radius gets in the way. A small relief groove solves it and gives a grinding wheel room to run out.

4. Use standard threads with a chamfer and run-out

Standard metric threads are cut and gauged with stock tooling. Put a chamfer at the start and a run-out groove at the end; full thread right up to a shoulder makes the job harder.

5. Avoid deep, narrow bores

The deeper the bore, the harder chip evacuation becomes and the more the boring bar deflects. Ask for precise diameters only over the length that needs them.

6. Take care with thin walls

Thin-walled parts go out of round under chuck pressure and change size when released. Keep the wall as thick as possible, or set the roundness tolerance realistically.

7. Tolerance only where it is needed

Fits and bearing diameters need tight tolerances; free surfaces do not. A general tolerance standard is enough for untoleranced dimensions.

8. Design close to standard bar sizes

Choosing the largest diameter close to an available bar size reduces both the material turned into chips and the machining time.

More about our service on the CNC Turning page.

Kalıp ve hassas parça işleriniz için üretim ortağınız

Kokil, plastik enjeksiyon ve alüminyum enjeksiyon kalıpları ile CNC talaşlı imalat tek atölyede. Teknik resminizi gönderin, birlikte değerlendirelim.

Bize Ulaşın
Kasım 16, 2026

Stainless Steel Grades in CNC Machining: 303, 304, 316, 420 and 17-4 PH

Devamını oku
Kasım 16, 2026

CNC İşlemede Paslanmaz Çelik Türleri: 303, 304, 316, 420 ve 17-4 PH

Devamını oku
Tüm haberler ve yazılar