Prototipten seri üretime, kalıptan bitmiş parçaya — İzmir'den. E-posta: info@oskakalip.com Telefon: 0506 462 17 78 WhatsApp Sohbeti Teklif Başlat
Fiyat teklifi alın

Ana Sayfa / Haberler

Hot Runner or Cold Runner? Choosing the Right Runner System

Kasım 16, 2026

Türkçe

In an injection mold the runner is the channel that carries molten plastic from the machine nozzle to the cavity. Whether that channel freezes and is ejected with every shot or is kept hot all the time has a direct effect on tool price, cycle time and part quality.

What is a cold runner?

In a cold runner mold the channel is machined into the mold plates and cools with the part in every cycle. After the shot the runner is separated from the part and is either reground or scrapped. The mold is simple, easy to maintain and quick to change colour.

What is a hot runner?

In a hot runner system the plastic is kept molten inside a heated manifold and nozzles and is fed directly into the cavity or into a short cold runner. The runner that would be thrown away with every shot disappears or becomes very small.

Criterion Cold runner Hot runner
Tool cost Low High (manifold, nozzles, temperature controller)
Material waste A runner with every shot None or very little
Cycle time Waits for the thick runner to cool Shorter
Colour and material change Fast Slower, needs purging
Maintenance Simple Needs expertise; heaters, thermocouples and tips are monitored
Heat-sensitive materials No issue Careful temperature control required
Large and multi-cavity molds Balanced filling gets harder Balanced filling at lower pressure

Hot runner nozzle types

  • Open (thermal) gate: the gate is shut by the thermal balance at the nozzle tip. Simple and economical; leaves a small gate vestige, and stringing or drooling can occur with easy-flowing materials.
  • Valve gate: the gate is opened and closed mechanically by a moving pin. Very clean gate mark, larger gate diameters possible, and sequential opening lets you control where weld lines form. More expensive, with more maintenance.
  • Hot runner to short cold runner: the nozzle feeds a small cold runner that distributes to the parts. Cuts waste on multi-cavity molds for small parts while keeping cost limited.

Which one, when?

  • Low annual volume, frequent colour changes or a limited tool budget usually point to a cold runner.
  • High volume, expensive resin or parts where regrind cannot be used (transparent, medical, food contact) let a hot runner pay for itself.
  • Large parts that cannot be filled from one gate need a multi-drop hot runner.
  • When no gate mark is acceptable on a visible face, a valve gate is considered.

Before deciding

Gate location, gate count and runner type together determine filling balance, weld lines and warpage. That is why we take the runner decision together with a mold flow analysis: comparing options while the mold is still on screen costs far less than changing them after the steel is cut.

Request a Quote

Kalıp ve hassas parça işleriniz için üretim ortağınız

Kokil, plastik enjeksiyon ve alüminyum enjeksiyon kalıpları ile CNC talaşlı imalat tek atölyede. Teknik resminizi gönderin, birlikte değerlendirelim.

Bize Ulaşın
Kasım 16, 2026

Stainless Steel Grades in CNC Machining: 303, 304, 316, 420 and 17-4 PH

Devamını oku
Kasım 16, 2026

CNC İşlemede Paslanmaz Çelik Türleri: 303, 304, 316, 420 ve 17-4 PH

Devamını oku
Tüm haberler ve yazılar